Gorilla Wood Glue is the adhesive that woodworkers carpenters and hobbyists trust for their woodworking projects. Gorilla Wood Glue a PVA glue offers the benefits of an easy-to use water-based adhesive with the holding power Gorilla is known for. This PVA glue is incredibly water resistant and dries a natural color that offers an invisible bond line for your projects. Directions: For best results it is essential that the wood surfaces are prepared prior to application of glue. For laminating the surfaces should be planed smooth leaving the board surface free from machine marks tear-out and snipes. Also be careful to avoid burnishing and end snipes. In general apply a generous amount of glue on one of the surfaces. On hard-to-glue woods apply the glue on both surfaces. Rub together with the other surface to distribute the glue evenly on both surfaces. Enough glue should be applied so that a fine bead of glue squeeze-out will occur when clamping. Coverage: One gallon of Gorilla Wood Glue will cover about 200 square feet. One fluid ounce will cover approximately 1.6 square feet. Clamping: The technique and type of clamp to be used is determined by many factors. In general apply enough pressure that will cause a fine bead of glue to squeeze out when the proper pressure is applied. Clamping Time amount of time pressure needs to remain applied: 2030 minutes for room temperature applications. The temperature must be above 55F. Note that clamping time can be dependent on temperature humidity and the porosity of the wood. Cure Time amount of time for glue to reach total bonding strength: 24 hours. Clean up while glue is wet: Use a clean damp cloth to wipe off excess glue. When areas have completely dried sand as needed. Click on the Gorilla link at the top of this page to see other quality products from the Gorilla Glue Company.